Operation And Performance; Temperature Control Settings; Fresh Food Control; Energy Saver Switch - GE Monogram ZIS36 Manual

Table of Contents

Advertisement

MONOGRAM REFRIGERATORS
ZIS MODELS
OPERATION AND PERFORMANCE
Temperature Control Settings
The temperature controls for both
compartments are located in the upper rear
of the fresh food compartment.
The control
knobs located in a console just in front of
the controls, have extensions which provide
the means to set the controls.
Both
controls, having settings "1" through "9",
should initially be set at "5".
At these
settings, under average use conditions, the
freezer temperature should be near 0° F and
the fresh food temperature approximately 38°
F.
The control positions are illuminated
by the upper fresh food lights.
The light
shield should be in-place for proper
lighting.
.
NOTE:
When changing a control setting, allow 24 hours for the temperatures to
stabilize before making another change.
Freezer Control
The freezer control is an electrical temperature control that senses air supply
temperature in the freezer compartment to regulate the compressor run time.
NOTE:
The freezer temperature control has an "off" setting which stops the
coolin~
for both compartments, but power is still on to the unit.
Fresh Food Control
The fresh food control is an automatic air damper control that senses air
temperature in the fresh food compartment to regulate the amount of cold air
supplied to the fresh food compartment.
Energy Saver Switch
The energy saving switch is located on the control console and between the freezer
and fresh food control knobs.
If moisture appears on the case flange or area
between the doors, position the switch to eliminate the moisture.
Icemaker
Automatic cycles of the icemaker can be stopped by ralslng the feeler arm up to
engage "OFF OR STOP" position.
Under average use conditions, the icemaker will
produce approximately
120
crescent shaped ice cubes in
24
hours until the feeler
arm senses the ice bin is full.
Condenser Cleaning
Anytime the refrigerator is being serviced,
for any reason, the top panel should be
removed and the condenser cleaned if
needed.
- 4 -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Monogram zis42Monogram zis48

Table of Contents