Honeywell ACS-8 Installation Instructions Manual page 91

Installation Instructions / ACS-8
Number
ST1
ST2
ST4
ST5
ST6
ST7
ST8
ST10
ST13
ST14
ST16
BU2
BU3
BU4 and BU5
LD100
LD1
LD3
LD4
Si1
Si2
DB1 and DB2
Explanation
Expansion connector for the external modem certificated by Novar GmbH
Expansion connector for communication module
Connector of the power supply unit
Watchdog and danger signal output
12V semiconductor outputs, 50mA, short-circuit proof
Jumper for the door strike monitoring
Connection of the cover contact
Jumper used to connect the watchdog to the alarm relay.
Monitored inputs 7 and 8 / inputs 11 and 12
(terminate by 12 kOhm)
Connector for LED board in the housing cover
Power supply connector for the controller voltage 45 and 46 (+12V DC, 0V)
Basic definition of the tamper and alarm relay (from PCB layout version no. 467.00-75-01/02)
Expansion connector for e.g. RAM cards
Service connector
Slot for the host interface card
The LED lights up if a watchdog reset occurred previously
Software LED (see chapters 9.6.1 and 11.1)
If this LED lights up, then the ACS-8 runs from flashbank 1
If this LED lights up, then the ACS-8 runs from flashbank 2
1,0AT, fuse for the terminals 13 and 22
1,0AF, fuse for the communication module at ST 2
Grounding/shielding (see chapter 5.1)
Jumper 1-3, or 2-4 = no door strike
monitoringJumper 3-5, or 4-6 = with door strike
monitoring (only admissible with connected door
strike art. no. 019042 / 019042.01. Deactivate if
other devices, such as a flash lamp, are connected
to these outputs/relays).
(Open = tampering)
Jumper 1-3 = relay 3 (alarm) energized on system failure
Jumper 2-4 = relay 4 (tamper) energized on system failure
Jumper 3-5 = relay 3 (alarm) deenergized on system failure
Jumper 4-6 = relay 4 (tamper) deenergized on system failure
PIN 1+ 2 = FREE
PIN 3 >1V->battery fault
PIN 4 = 10-15V
PIN 5 = 0V
PIN 6 <1V-> power failure
PIN 1 = 0V,
PIN 2 = watchdog output,
PIN 3 = output 6
PIN 1 = monitored input 7/ input
11
PIN 2 = 0V
PIN 3 = monitored input 8/ input
12
91