Table of Contents
Advertisement
Inserting SIMMs
From the table of possible SIMM combinations decide
which SIMM capacity will be installed in each bank. Then,
working from the socket nearest the front of the system
unit towards the rear, install the SIMMs.
To fit a SIMM:
1. Hold the SIMM so that the memory chips are facing
the front of the system unit with the connector
nearest the system board.
2. Position the SIMM above the socket at an angle of
about 15° to the vertical.
3. Lower the SIMM towards the socket. The right edge
of the SIMM will be prevented from reaching the
connector by the securing clip.
4. Allow the left edge of the SIMM to drop into the
connector.
5. Push the SIMM gently to the right and lower the
right edge into the connector.
6. Ensure that the SIMM is properly located in the
connector.
21
Advertisement
Table of Contents
