Audio; Pixel Counter - Bosch AUTODOME IP starlight 5000i IR User Manual

40 en | Camera
IR Operation Range
Select the zoom factor or range for the IR light:
–
–
–
–
The focal length of the lens determines the intensity level of the illuminator. The more the
camera zooms in, the more power is put on the IR near and far.
Spotlight mode
Select On to set the camera in spotlight mode, which increases the IR intensity values at the
zoom at which the camera is set. Use this mode to see objects at far distances when the
camera is zoomed to a wide angle. Note that an IR beam will be visible in the field of view.
By default, this option is Off.
6.20

Audio

Audio
You can set the gain of the audio signals to suit your specific requirements. The live video
image is shown in the window to help you check the audio source. Your changes are effective
immediately.
If you connect via Web browser, you must activate the audio transmission on the 'Live'
functions page. For other connections, the transmission depends on the audio settings of the
respective system.
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data is encoded according to the selected format and requires
additional bandwidth. If you do not want any audio data to be transmitted, select Off.
Input volume
Set the input volume using the slide. Values range from 0 to 119.
Line Out
Set the line output gain using the slider. Values range from 0 to 115.
Recording format
Select a format for audio recording. The default value is AAC 48 kbps. You can select AAC 80
kbps, G.711 or L16 depending on the required audio quality or sampling rate.
AAC audio technology is licensed by Fraunhofer IIS.
(http://www.iis.fraunhofer.de/amm/)
6.21

Pixel Counter

The number of horizontal and vertical pixels covered by the highlighted area is displayed
below the picture. With these values you can check whether the requirements for specific
functions, for example, identification tasks, are fulfilled.
1.
2.
3.
2019.11 | 1.2 |
1X-30X (default)
10X-30X
15X-30X
20X-30X
Click Freeze to freeze the camera image if the object that you want to measure is moving.
To reposition a zone, place the cursor over the zone, hold down the mouse button and
drag into position.
To change the shape of a zone, place the cursor over the edge of the zone, hold down the
mouse button and drag the edge of the zone to the required position.
User Manual
AUTODOME IP starlight 5000i IR
Bosch Security Systems