Carry Strap; Maintenance; Optional Accessories - DeWalt DE7035 Original Instructions Manual

EN GLI SH
Mounting a Sacrifi cial Wood Surface
(fi g. 4)
The DE7035 work stand allows a 100 mm x
50 mm piece to be mounted in the top channel of
the beam (a) as a sacrifi cial element when needed.
This can be useful if working with a material that
could get scratched by the main beam or when
using a circular saw to cut material.
To mount the wood piece:
1. Cut a standard 100 mm x 50 mm piece (h) to
910 mm long.
2. Align the 100 mm x 50 mm piece in the top
channel of the beam (a).
3. Secure the 100 mm x 50 mm piece to the
beam with 50.8 mm long wood screws inserted
from below through the holes in the main beam.
NOTE: When the wood surface is attached, a mitre
saw mounting bracket can not be attached to the
stand.
Working With Pipes (fi g. 5)
If cutting or otherwise working with pipe, the stand
has a V notch (i) on each side of the stand to help
keep the pipe from rolling when cutting.

Carry Strap

If you purchase the carry strap accessory for
D WALT stands, use the small square hole in the
E
metal end to mount the accessory.
Wall Mount Storage
If you would like to store your stand out of the way
you can mount your stand on the wall. Install a
wood screw into a stud, leave a portion protruding
from the wall. Use the V notch on the bottom of the
metal end to hang the stand vertically on the screw.
WARNING: To reduce the risk of
personal injury, DO NOT attempt
to store the work stand with a tool
attached. Loss of control may result.
Locking Locator Clip (fi g. 6)
The locking locator clip (j) keeps the optional
DE7025 accessory from sliding left or right during
cutting operations. It is fi xed on the DE7035.
Carry Handle (fi g. 7)
A handle (b) has been supplied to transport the work
stand to and from the work site.
16
WARNING: To reduce the risk of
personal injury, DO NOT attempt to
transport the work stand with a tool
attached. Loss of control may result.
Clamping Work Material (fi g. 8)
The work stand is compatible with the DWS5026
track saw clamp. Insert the clamp's base into the
large rectangular hole (k) in the stand end bracket
and clamp down on your work material.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Cleaning
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
COMPATIBLE PRODUCTS
DE7025 Mitre saw mounting brackets
DE7026 Carry strap
DWS5026 Track saw clamp
WALT, have
E