Troubleshooting - Toshiba AR100 User's Information Manual

AR100 Viewer

Troubleshooting

In the unlikely event you find the AR100 Viewer is not working as expected
please refer to the following scenarios and suggested resolutions. Refer
to the online user's manual for detailed information and instructions
concerning the dynaEdge.
Power
Problem
The AR100 Viewer turns
on but shuts down soon
after, automatically.
The AR100 Viewer
cannot be powered on.
Display
Problem
No display.
The screen does not
display properly.
EN-8
Procedure
The battery of your dynaEdge might be
drained.
■ ■ Connect the power cord/adaptor of the
dynaEdge to charge it.
■ ■ Replace the battery pack of the
dynaEdge with a charged one.
The internal temperature of the dynaEdge
has reached an unacceptably high level,
and to prevent any damage, the dynaEdge
automatically shuts down.
■ ■ Leave the dynaEdge off until it reaches
room temperature.
■ ■ Do not block the cooling vents of the
dynaEdge.
If you are still unable to resolve the problem,
contact TOSHIBA Support.
Procedure
Make sure the dynaEdge is powered on.
Check the connections to make sure that
the AR100 Viewer is correctly connected to
the dynaEdge.
The battery of your dynaEdge might be
drained.
■ ■ Connect the power cord/adaptor of the
dynaEdge to charge it.
■ ■ Replace the battery pack of the
dynaEdge with a charged one.
Make sure the resolution is set to 1280x720
pixels by clicking Start ->
System -> Display -> Resolution.
If necessary, please operate the dynaEdge
by connecting it to an external monitor.
If you are still unable to resolve the problem,
contact TOSHIBA Support.
(Settings) ->
User Information Guide