Philips SPN5087C/10 User Manual

Additional information about your energy efficient surge protector
Features
Your energy efficient surge protector is specifically designed to fit within
your home theater setup. You can conveniently control the on/off of your
devices in either zone 1 or zone 2 outlets with your remote control. When
switched to the off position, it eliminates the consumption of the stand-by
power to these outlets, bringing energy savings to your fingertips.
Zone 1 & 2 outlets group your devices by usage.
Always on outlets remain on even when other outlets are switched off
– these are ideal for devices which have volatile memory and require
constant power. (i.e. cable modems, DVRs , set top boxes, etc)
Remote control turns your devices on/off in zone 1 & zone 2 with the
touch of a button.
Cable management clips help eliminate cable clutter.
LED indicators on the front of the unit provide worry-free protection and
show that your surge protector functions properly.
Power – (blue) shows that the power is running to your devices.
Protecting – (red) shows that your surge protector is actively
protecting your devices.
Zone 1 & Zone 2 – (green) lights to show that the group of outlets
have been switched on.
Instructions for changing the remote control battery
NOTE: If the remote control device stops working, replace the battery.
Step 1 - Turn the unit over and slide open the battery compartment cover.
Step 2 - Remove and dispose of the old battery properly. Do not throw the old
battery in the trash.
Step 3 - Insert a new battery and close the compartment cover. Replace ONLY
with a 3 volt CR2032 type button cell battery.
NOTE: The remote control with this unit operates on either channel A or channel B frequency. If you have purchased
more than one unit, make sure you have two different frequencies (A and B) as indicated by stickers on the bottom of
the unit and on the packaging.
TV
AMP
Zone 2
Always on
POWER
ZONE 1
PROTECTING
Remote control
EN
STB
DVD
Zone 1
Cable management clips
ZONE 2