Note: Install the screws from the underside of the
panel as shown in
Figure
Figure 9
1. Locknut
2. Fuse block
6. Mount the power relay to the inside of the control
panel with a screw and nut
Figure 10
7. Remove the knock-out plug from the side of the
control panel
(Figure
9.
3. Screw
(Figure
10).
11).
1. Power point in knockout
location
8. Unscrew the outer shell from the threaded power point
connector body.
9. From the seat side of the control panel, insert the
power point into the hole, secure it with the outer shell,
and insert the cap into the power point.
4
Figure 11
2. Cap