Removing The Transport Screws From The Cd Player; Connection.6 - Pioneer CJ-V55 Service Manual

REMOVING THE TRANSPORT SCREWS FROM THE CD
PLAYER
The vibration-protection of the CD player is fixed with three
screws for shipping.
© Remove the screws and spacer on the front center.
(Keep the removed screws in the pocket inside the main unit
door in case it becomes necessary to move the unit again.)
@ Remove those screws on both sides of the front, and install
them to the holes indicated by the arrows.
When transporting the CD player, make sure to install the
screws for protection.
CONNECTION
CONNECTING THE CD PLAYER
©Connect the CD player's CONTROL jack to the controller's
CONTROL jack with the supplied control cord.
<2) Connect the CD player's AUDIO OUT jacks to the amplifier's
INPUT jack with the supplied audio cord.
(D Connect the CD player's power cord to the AC OUTLET of the
amplifier section.
©Connect the ground wire to the ground terminal.
CONNECTING THE EXTERNAL SPEAKERS
• External speakers can be connected to the EXTERNAL
SPEAKERS terminals located on the rear of the main unit.
• Connect the * + " terminals on this unit to the " +" terminals on
the speakers, and the terminals on the unit to the " —"
© Loosen cap.
© Insert wire.
© Tighten cap.
NOTE:
Do not allow any of the cord's conductors to protrude from the
terminals or touch any other conductors. Malfunctions or
breakdowns may occur when conductors come into contact with
each other.
Speaker impedance
Connect speaker systems with a nominal impedance of between
8 and 16 ohms.
Setting of speaker selector switch
When using only the built-in speakers, set the switch to the right.
When using both built-in and external speakers, set the switch to
the left side.
When combining with other devices (such as an
amplifier)
Connect the LINE OUT jack located on thd rear panel to the input
jack of the other device.
CONNECTING THE POWER CORD
After completing connection of all signal lines, connect the
power cord to the wall outlet.
<DRA1107>