5 EXTRACTING RSSI SIGNAL FROM THE ACC 25-PIN D-SUB CONNECTOR
It is possible to extract the RSSI signal from the pin 1 of
the ACC 25-pin D-Sub connector (Default: No
Connection).
Follow the procedures below to modify the connector.
Note: The part number of the ACC 25-pin D-Sub connector is
"E37-0904-05".
It must turn the power OFF before modifying the connector.
1. Remove the FRONT PANEL of the TKR-750/850/751/
851.
Follow the steps 1 - 3 in "
2. Cut the connector 27-pin cable (CN606) located on
the printed board of the "E37-0904-05".
Note:
Cut and remove the wire from the top of connector.
3. Solder the wire to the RSSI land of the printed circuit
board.
4. Reassemble the repeater after modifying the
connector.
13
3.2 Installing the
SC20-460".
Connect the wire here.
Modification Information (MOD)
Version: 1.02 USA