Unpacking The Appliance - LG S3 F Series Owner's Manual

Closet Ventilation Requirements
Closets with doors must have both an upper and
lower vent to prevent heat and moisture build-up in
the closet.
One example shown uses vent grilles in the door.
• One upper vent opening with a minimum
opening of 310 cm must be installed no lower
2
than 185 cm above the floor.
• One lower vent opening with a minimum opening
of 155 cm must be installed no more than 30.48
2
cm above the floor.
Electrical Connection
• Install where an outlet is easily accessible.
• Use an individual, grounded outlet: 220–240
Volts, 50 Hz, AC, 8 Amps minimum.
WARNING
• Do not plug in multiple appliances in the same
outlet with the appliance. Overloading house
wiring can cause a fire hazard.
• To reduce the risk of electric shock, do not
install the appliance in a wet or damp area.
Ambient Temperature
• Temperature must be between 10°C and 35°C.
• If the ambient temperature is too low or high,
performance may be affected.
• Do not install in direct sunlight or where the
temperature may fall below 0°C.

Unpacking the appliance

Removing carton and shipping
materials
Unpack the appliance from carton then remove any
tapes and temporary labels from the appliance.
• Do not remove any warning labels, the model
and serial number label, or the technical sheet
label that is located under the front of the
appliance.
7.6 cm
Vent
310 cm
Vent
155 cm
7.6 cm
Closet door vent requirements
WARNING
• The appliance should be unpacked and moved
by two or more people. Failure to do so can
result in serious injury by tipping the appliance.
CAUTION
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to
remove tape or glue. These products can
damage the surface of the appliance.
NOTE
• Tape or glue residue can also be easily removed
by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with
warm water and dry.
EN
2
2
15