Introduction; Specifications - Motorola MVME710 User Manual

O M O T O R O L A

1.1 INTRODUCTION

This u s e r manual p r o v i d e s g e n e r a l i n f o r m a t i o n , h a r d w a r e p r e p a r a t i o n and
support information f o r t h e MVME710 8 -Channel S e r i a l I / O D i s t r i b u t i o n Module
(hereafter r e f e r r e d t o as t h e MVME710).
NOTE: References t o MVME332 a l s o apply t o MVME332XT.

1.2 SPECIFICATIONS

The MVME710 s p e c i f i c a t i o n s a r e d e t a i l e d i n t h e f o l l o w i n g t a b l e .
TABLE 1-1. MVME710 Specifications
Characteristic S p e c i f i c a t i o n
Serial p o r t
configurations
Supported RS-232C
signals and corresponding
connector p i n numbers
Physical dimensions
Connectors
Power requirements
CHAPTER 1
GENERAL INFORMATION
Each s e r i a l p o r t may be configured i n t h e
"Connect t o Terminal" (DCE) o r t h e "Connect t o
Modem" (DTE) mode v i a jumper arrays.
P G N D - p r o t e c t i v e ground
TxD - t r a n s m i t data
RxD - receive data
RTS - request t o send
CTS - c l e a r t o send
D S R - data s e t ready
S G N D - signal ground
D C D - data c a r r i e r detect
DTR - data terminal ready
Double height/reduced depth VMEmodule
Board s i z e : 9 . 1 9 x 3.15 i n . (233 x 80 mm)
Front panel s i z e : 1 0 . 3 x 1.56 i n . (262 x 40 mm)
One DIN 41612 C64 f o r ribbon c a b l e i n t e r c o n n e c t
with t h e MVME332
Eight sub-D 25 conductor s e r i a l I / O connectors
No power consumed a t +5, +12, - 1 2 VDC
1
GENERAL INFORMATION
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(20)
1