Interfaces
"Standard" versions
①
Connector for protective conductor
②
X80 connector for 24 V DC power supply
③
X71 DVI-D interface
④
X70 DisplayPort interface
⑤
X60 USB Type B
Installing devices
Permitted mounting positions
For IFP2200 MT devices, the mounting positions and ambient temperatures specified in the operating instructions "Industrial
Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP1900 ETH, IFP2200 ETH" apply.
Mounting cutout
Dimensions of the mounting cutout for installation of IFP2200 MT devices in landscape mode: 513
Width and height should be reversed accordingly when mounting in vertical format.
The specifications for stability of the mounting cutout and degrees of protection in the operating instructions "Industrial Flat
Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP1900 ETH, IFP2200 ETH" apply.
Position of the mounting clips for IP66-complaint installation
Fasten the mounting clips (available as accessory) to the positions as illustrated.
Device
22" display
Connecting the power supply
The specifications in the operating instructions "Industrial Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO,
IFP1900 ETH, IFP2200 ETH" apply. Refer to the section "Connecting a DC power supply" for information on connecting the
power supply.
Note
The device may only be connected to a 24 V DC power supply that meets the requirements of a safe extra-low voltage
(SELV) according to IEC/EN/DIN EN/UL 60950-1.
The power supply must meet the requirements of NEC Class 2 or LPS according to IEC/EN/DIN EN/UL 60950-1.
SIMATIC IFP2200 MT
A5E37770549-AD, 04/2019
"Extended" versions
①
Connector for protective conductor
②
X80 connector for 24 V DC power supply
③
X71 DVI-D interface
④
X70 DisplayPort interface
⑤
X61/X62 USB Type A
⑥
X63 USB link interface
⑦
X60 USB Type B
Position
× 315
mm (width × height).
+1
+1
7