Mitsubishi Electric MP-G10-AH Technical Manual page 10

4.5 Installing the setting
CAUTION
If the sewing machine is oper ated with the magnetic clamp settings, f aults
could occur.
(1) Installing the system software
Always change setting f or the pneumatic type clamp.
① Turn the sewing machine power switch ON.
(1) Points changed in setting details
Please change setting as follows.
Function
Mode
Stitching
area
Presser
Presser
Home
position
Home
position
Home
position
Stitching
speed
Input/output
setting
Input/output
setting
Input/output
setting
Input/output
setting
Two stage clamp
name setting value
ALC ON
WHY ON
FN 2
HPM JE
HPF ON
HPS ON
HIGH 2,300
O4 66H
O5 66H
O7 FN3
O7 66H
- 8 -
Default
value
OF Stitching area limit is canceled
OF Pressing order of priority setting
1 Valid number of clamps setting
Home position
－－
when operation is halted
Prohibition of automatic home
OF
position return operation
Presser state setting during home
OF
position return at power ON
2,800 Maximum speed
Set this when changing from the
33 magnetic drive clamp to the
pneumatic drive clamp
Set this when changing from the
33 magnetic drive clamp to the
pneumatic drive clamp
NO Set of Function code 3
Set this when changing from the
33 magnetic drive clamp to the
pneumatic drive clamp
Remarks
return method