Hardware Specifications - Honeywell MPA2 Installation Manual

Installing the MPA2 Panels

Hardware Specifications

5.0 Hardware Specifications
The specifications in this section apply to both the Standard Enclosure and
Compact Enclosure panels.
5.1 Primary input Voltage
• The primary input voltage to the powers supply is 100-240VAC,
• The primary input voltage must be conduit connected when
• For UL and ULC Installations: the primary input voltage must be
5.2 Relay Contacts
Maximum of 4 Form-C SPDT relays, 3A (at dry contact) or 500mA (at
self-wetted) @ 30VDC (PTC limited in the self-wetted mode). The Form-C
SPDT relays are configured as Normally Open or Normally Closed outputs
only. Normally Open and Normally Closed contacts cannot be used
simultaneously.
5.3 Reader Interface
• Reader Power: 12VDC nominal with 500mA maximum Current
• Reader LED Output: Open collector driver capable of sinking up to
• Reader Tamper: ADC input.
• Reader Data Input: Low Voltage CMOS.
5.4 Maximum Output Loading
Use the following guidelines unless you are using Power Over Ethernet
(PoE):
• Maximum current for reader port is 500mA per door (= 2 Reader
• Maximum current for any of the 4 relay outputs at dry contact, or
• Door 1: Rel1/RelAUX1
• Door 2: Rel2/RelAUX2
• Maximum battery charge current for the battery wired in series is
• External power is limited to 500mA/12 VDC per AUX Output (2X).
54 www.honeywell.com
50/60Hz.
installed using 230/240VAC Primary.
conduit connected when installed using 230/240 VAC.
available for each door. (= 2Reader Ports)
16mA.
Connections).
750mA per door self-wetted.
250mA.