Advertisement
LC2H_Preset.fm Seite 84 Donnerstag, 24. Juni 2004 3:31 15
LC2H
PRECAUTIONS IN USING THE LC2H SERIES
CAUTIONS FOR USE
1. Insulation sheet
Before using a panel mounting type,
please pull and remove the insulation
sheet from the side of the product in the
direction of the arrow.
In consideration that the product might be
stored for long periods without being
used, an insulation sheet is inserted
before shipping. Remove the insulation
sheet and press the front reset button.
• LC2H total counter (one-touch
installation type)
Reset button
Insulation sheet
• LC2H total counter (installation frame
type)
Reset button
Insulation sheet
2. Waterproof construction
• LC2H total counter (installation frame
type)
The operation part of the panel
installation type (installation frame type) is
constructed to prevent water from
entering the unit and a rubber gasket is
provided to prevent water from entering
the gap between the unit and the panel
cutout.
There must be suf ficient pressure applied
to the rubber gasket to prevent water from
entering.
Be sure to use the mounting
reinforcement screws when installing the
mounting frame (ATH3803).
Note: The one-touch installation type is
not waterproof.
Mounting frame
(ATH3803)
84
• LC2H preset counter
1) The front plate will not be waterproof
when this product is installed on a panel.
To make the front plate waterproof, please
install the following.
When using the waterproof type (IP66:
panel front only), install the counter to the
front plate with mounting frame ATH3803
(sold separately) and rubber gasket
ATH3804 (sold separately). Be sure to
tighten using mounting screws.
Mounting frame
(ATH3803)
Rubber gasket (ATH3804)
When installing the mounting frame
and rubber gasket please remove the
pre-attached o-ring.
2) Panel installation order
(1) Remove o-ring.
(2) Place rubber gasket.
(3) Insert counter into panel.
(4) Insert mounting frame from the
rear.
(5) Secure with mounting screws (two
locations)
3. Do not use in the following
environments
1) In places where the temperature
changes drastically.
2) In places where humidity is high and
there is the possibility of dew.
(When dew forms the display may vanish
and other display errors may occur.)
4. Conditions of use
1) Do not use on places where there is
flammable or corrosive gas, lots of dust,
presence of oil, or where the unit might be
subject to strong vibrations or shocks.
2) Since the cover is made of
polycarbonate resin, do not use in places
where the unit might come into contact
with or be exposed to environments that
contain organic solvents such as methyl
alcohol, benzene and thinner, or strong
alkali substances such as ammonia and
caustic soda.
07/2004
Advertisement
