Advertisement
5.3.
tool iNSeRtioN, fig.3
5.3.1.
Clean the tool before insertion and apply a thin coating of drill bit grease to the shaft of the tool.
5.3.2.
Pull back and hold the locking sleeve (2).
5.3.3.
Insert the dust-free tool into the tool mounting as far as it will go whilst turning it. The tool will lock itself.
5.3.4.
Check that it is properly secure by pulling the tool.
5.4.
tool RemoVal, fig.4
5.4.1.
Pull back and hold the locking sleeve (2) and remove the tool.
5.5.
DuSt ColleCtioN DeViCe, fig.5
5.5.1.
Slide the dust collection device (a) over the drill bit before carrying out any hammer drilling vertically above your head.
fig.3
5.6.
SWitCHiNG oN/off
5.6.1.
Press switch, fig 1.4 to turn on and release to switch off.
5.7.
RotaRy moDe SWitCH refer to illustrations below
HammeR (loCKeD)
HammeR DRill
Note: It is not possible to operate the hammer drill with the hammer stop and rotation stop facilities both active at the same time.
imPoRtaNt: only low pressure is required for hammer drilling. excessive pressure will exert an unnecessary force on the motor.
Check drill bits at regular intervals. Sharpen or replace blunt drill bits.
6. maiNteNaNCe
WaRNiNG! Remove from mains supply before performing any maintenance.
‰
6.1.
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
6.2.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure, wear PPE as necessary.
6.3.
Clean after each time tool is used. Clean the tool regularly with a moist cloth and some soft soap.
Do Not use cleaning agents or solvents; these could attack the plastic parts of the equipment. ensure that no water can seep into the
8
device.
© Jack Sealey limited
fig.4
HammeR (fRee RotatioN)
Original Language Version
fig.5
SDSMAX40 Issue 1 09/09/19
Advertisement
