Husqvarna 120iB Operator's Manual page 15

3. When all LEDs on the battery come on, the battery is
fully charged.
3
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries in the product.
1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it is not
installed correctly.
3. Press the lower part of the battery and push it in as
far as it will go into the battery compartment. The
battery will lock into position when you hear a click.
4. Make sure that the latches snap in place correctly.
1310 - 003 - 23.12.2019
2 1
To start the product
1. Push and hold the start button until the green LED
light comes on.
2. Use the power trigger to operate the product.
To set the optimal airflow for your work
• Push the mode control button to set the airflow.
There are 3 airflow steps. The LED shows the set
airflow.
To stop the product
1. Release the power trigger.
2. Push and hold the stop button until the green LED
light comes off.
3. Remove the battery from the product. Push the two
release buttons and pull out the battery.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The product shuts
down after 30 minutes.
15