Eu Declaration Of Conformity; Sms Commands - Husqvarna Automower Connec Operator's Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 14
are permitted to communicate using SMS
must be entered in the SMS phone numbers
list. The numbers must be entered using
country code prefix, e.g. (+)46701234567. To
verify the entered phone numbers, the Test
SMS function can be used. This will send a
test SMS to all phone numbers listed.

2.2 SMS commands

If the SMS function is enabled, an SMS will be
sent to all listed phone numbers if the mower
has a fault or is outside the Geofence. In
addition to that, some information can be
retrieved from the mower by sending an SMS
to it. Note that the sender's phone number
must be listed in the mower. The following
commands can be sent to the mower:
Command
GET STATUS
GET GPS INFO
GET GSM INFO
Automower Connect_multilingual.indd 15
Response
The mower status (e.g.
Mowing, Charging,
Parked etc)
The position of the
mower, the Geofence
home position and
radius along with the
GPS signal strength
Details of the carrier
and GSM signal
strength
3 EU Declaration
of Conformity
Husqvarna AB, SE-561 82 Huskvarna,
Sweden, hereby declares under sole
responsibility that the GSM/GPRS module with
serial numbers dating year 2014 week 45 and
onwards (the year and week is clearly stated
on the rating plate, followed by the serial
number), comply to the requirements of the
COUNCIL'S DIRECTIVE lister below.
The Automower® Connect is intended to be
used only in Husqvarna Automower® 330X
and Automower® 320.
Directive on "restriction of use of certain
hazardous substances" 2011/65/EU.
Directive "relating to electromagnetic
compatibility" 2004/108/EC and
applicable supplements.
The following standards have been
applied:
- EN 301489-1 V1.9.2 (2011)
Electromagnetic compatibility and Radio
spectrum Matters (ERM) – Electro
Magnetic Compatibility (EMC) standard
for radio equipment and services.
Part 1: Common technical requirements.
- EN 301489-7 V1.3.1 (2005)
Electro Magnetic compatibility and Radio
spectrum Matters (ERM) – Electro
Magnetic Compatibility (EMC) standard
for radio equipment and services.
Part 7: Specific conditions for mobile and
portable radio and ancillary equipment of
digital cellular radio telecommunications
systems (GSM and DCS).
Huskvarna, February 1, 2015
Tom Söberg, Director of R&D Electric,
Husqvarna robotic lawnmowers
(Authorized representative for Husqvarna AB
and responsible for technical documentation)
EN
2015-04-02 15.26

Advertisement

Table of Contents
loading

Table of Contents