Toro 74946 Software Manual page 4

Engine Screens
Engine-Off Screen
When the key is on without the engine running, the
Engine-Off screen displays
1. Hours remaining until transmission fluid maintenance is
required
2. Battery voltage display
3. Safety interlock status indicators
4. Fuel-level gauge (if fuel sender is available)
5. Screen toggles between hours remaining until engine oil
maintenance and non-resettable engine hour counter
Engine-On Screen
When the engine is running, the Engine-On screen
displays (Figure 4).
1. Engine speed mode
2. Safety interlock status
indicators
3. Engine temperature
(Figure 3).
Figure 3
Figure 4
4. Engine speed
5. Fuel level gauge (if fuel
sender is available)
Engine Speed Mode
3 modes are available: L
•
L : Low transport speed/Low idle for reducing
OW
deck packing in wet mowing conditions.
•
E : Medium transport speed and maximum
FFICIENT
fuel economy and normal mowing conditions.
•
M : Maximum transport speed/High idle for
AX
extreme mowing conditions.
The panel illuminates showing the current engine
speed mode (Low is selected in
Safety Interlock Status Indicators
g030172
These illuminate when each control is in the starting
position (i.e., PTO disengaged, parking brake
engaged, motion-control levers in the N
position, and the operator is present).
•
The PTO must be disengaged, brake engaged,
and motion-control levers out (N
position) to start the engine. (You do not need to
be in the seat to start the engine.)
Note:
The starter cranks with the PTO switch in
the O (pulled up) position; however, the system
N
disengages the PTO and a PTO reset error occurs.
Engaging the PTO requires you to reset the PTO
switch by turning it O
•
You must be in the seat while the PTO is engaged,
the parking brake must be disengaged, or the
motion-control levers must be moved inward;
otherwise, the engine shuts off.
•
The engine shuts off if either the left, the right,
or both levers are moved from N
position while the parking brake is engaged.
Note:
Refer to the machine Operator's Manual to
check the safety interlock system.
g030173
Engine Temperature
A bar graph displays the engine temperature. When
the temperature is high and approaching an overheat
condition, the bar graph flashes. When the engine
has overheated, the bar graph fills completely.
Engine Speed
Displays the speed of the engine.
Fuel Level (if fuel sender is available)
The fuel level is shown on a bar display. An error
appears when the fuel level is low (approximately 1
gallon remaining in the tank).
4
, E , and M
OW FFICIENT AXIMUM
Figure 4).
-L
EUTRAL
-L
EUTRAL OCK
(pushed down) and O
FF
-L
EUTRAL OCK
.
OCK
.
N