Black & Decker BDHR202 Original Instructions Manual page 6

ENGLISH
Voltage Amperes
115 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Features (Fig. E)
This tool includes some or all of the
following features.
1. Variable speed switch
2. Lock-on button
3. Mode selector
4. Tool clamp
5. Side handle
6. Depth stop
7. Forward / Reverse lever
Assembly
Warning! Before assembly, make sure that
the tool is switched o and unplugged.
Attaching the Side Handle (fig. E)
Warning! When drilling holes in concrete or
bricks, please use the side handle for your
safety.
• Turn the grip counterclockwise until you
can slide the side handle onto the front
of the tool.
6
(Original instructions)
Cable rated current (Ampere)
6 6 6 6 6 10
6 6 6 6 15 15
6 6 10 15 20 20
10 10 15 20 20 25
15 15 20 25 25 -
20 20 25 - - -
6 6 6 6 6 6
6 6 6 6 6 6
6 6 6 6 10 15
10 10 10 10 15 15
15 15 15 15 20 20
20 20 20 20 25 -
• Rotate the side handle into the desired
position.
• Tighten the side handle by turning the
grip clockwise.
Warning! When using the tool, remember to
install the side handles properly.
Fitting an accessory (fig.A)
• Clean and grease the shank (15) of the
accessory.
• Insert the accessory bar into the tool
clamp(4).
• Push the accessory down and turn it
slightly until it fits into the slots.
• Pull on the accessory to check if it is
properly locked. The hammering and
drilling function requires the accessory to
be able to move axially several
centimetres when locked in the tool
clamp.
• To remove the accessory, pull back the
sleeve (8) and pull out the accessory from
the tool clamp.
Use
Warning! Please operate tool with normal
load. Do not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
Selecting the Operating Mode (fig. B)
The tool can be used in two operating
modes. Based on actual work requirements,
the drilling mode selector (3) can be rotated
to the required position.
Hole drilling / Screw driver (Fig. B, F, G, H )
• For drilling in steel, wood and plastics, or
tighten and loose screw set the operating
mode selector (3) to the ( ) position. At
the same time, it is necessary to use a
suitable drill chuck (13) (optional
accessory) to clamp the attachmentrod.