Configuring The Storage System - Bosch DSA E‑Series Installation Manual

34 en | Configuring the storage system
7

Configuring the storage system

This chapter describes the basic configuration of the storage system using the Configuration
Manager program.
To create a basic configuration:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Click Yes to confirm that you want to proceed with the basic configuration. The Basic
11. Click the Status tab to display the status of the configuration process.
12. Click the Reload page
13. In the device tree, right-click the storage system, then click LUN Assignment.... The LUN
14. Drag the Target x folder from the left side (Source) to the right side (VRM System), then
15. In the device tree, below the storage system, click Target x. All assigned LUNs are
16. In the view pane, click Select All, then click Set. The LUNs are displayed with the status
17. Click Yes to confirm. The status of the LUNs changes to Ready. The LUNs are formatted.
2020-05 | V2 | DOC
Start the Configuration Manager program.
On the toolbar, click the Devices tab, right-click the corresponding device in the tree
structure, then click Add to System....
The Add Device to System dialog box is displayed.
Select an existing group to assign the device or leave the field empty if you do not want
to assign the device to a group.
Click OK. The device is added to the system.
On the toolbar, click the My Devices tab.
In the device tree, click the corresponding device, click Pool x, click Storage Systems,
then click the storage system.
In the view pane, click the Basic configuration tab. The basic configuration settings of the
storage system are displayed.
Enter the basic settings of your storage system.
Click Initialize. An information message box is displayed.
Configuration for the iSCSI system dialog box is displayed. The dialog box shows the
status of the configuration process.
Click the Details tab to display details about all processes.
Click Close to close the dialog box.
Assignment dialog box is displayed.
Note: If multiple iSCSI ports are used, distribute the LUNs equally among the logical
iSCSI targets. Do not assign one LUN to multiple logical iSCSI targets.
click OK.
displayed with the status Unformatted.
Task format and a warning message box is displayed that informs you that formatting a
disk will erase all data.
icon.
Installation manual
DSA E-Series (E2800 60-bay)
Bosch Security Systems B.V.