Adjusting The Height Of Cut - Toro Greenmaster Flex 1820 Operator's Manual

Figure 12
1. Sideplate-mounting flange
2. Spacer
1. Raise the rear of the cutting unit and place a
block under the bedknife.
2. Remove the 2 nuts securing each roller bracket
and spacer to each sideplate mounting flange.
3. Lower the roller and screws from the sideplate
mounting flanges and spacers.
4. Place the spacers onto the screws above or
below the roller brackets, as required
11 or Figure 12).
5. Secure the roller bracket and spacers to the
underside of the mounting flanges with the nuts
previously removed.
Note:
The position of the rear roller to the reel
is controlled by the machining tolerances of the
assembled components and paralleling is not
required.

Adjusting the Height of Cut

Use the following chart to determine which bedknife is
best suited for the desired height of cut.
Bedknife Part No.
Edgemax 115-1880
Micro-cut
(Standard)
Edgemax 115-1881
Tournament
(Optional)
Micro-cut 93-4262
(Optional)
Tournament 93-4263
(Optional)
Extended 108-4303
Micro-cut
(Optional)
Extended 108-4302
Tournament
(Optional)
g014405
3. Roller bracket
(Figure
Height-of-Cut
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
Low-cut 93-4264
(Optional)
High-cut 94-6392
(Optional)
Fairway 63-8600
(Optional)
Fairway 112–7475
EdgeMax
(optional)
Note:
For heights of cut greater than 9.5 mm (0.375
inch), install the high-height-of-cut kit.
Adjusting the Height-of-Cut Gauge
Before adjusting the height of cut, set the height-of-cut
gauge as follows:
1. Loosen the nut on the gauge bar and set the
adjusting screw to the desired height of cut
(Figure 13).
Note:
The distance between the bottom of the
screw head and the face of bar is the height of
cut.
1. Gauge bar
2. Height-adjusting screw
2. Tighten the nut.
11
4.7 to 25.4 mm (0.188 to
1.00 inch)
7.9 to 25.4 mm (0.312 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
Figure 13
3. Nut
g000489