Philips PureForm Installation Instructions

INSTALLATION INSTRUCTIONS
WARNINGS AND INSTRUCTIONS FOR LUMINAIRES
IMPORTANT: FOR YOUR PROTECTION, YOU MUST CAREFULLY READ ALL WARNINGS AND INSTRUCTIONS IN THEIR ENTIRETY PRIOR TO
INSTALLATION, OPERATION, SERVICE OR MAINTENANCE. FAILURE TO DO SO CAN RESULT IN DEATH, PERSONAL INJURY AND PROPERTY DAM-
AGE. If you do not understand these warnings and instruc ons, or if addi onal informa on is desired, please contact Philips at
SanMarcos.TSC@philips.com
 Installa on, service and maintenance of luminaires must be performed by a qualified professional and in accordance with all federal, state and local
laws, regula ons and electrical codes. This professional should be familiar with the construc on and opera on of this product and any hazards in-
volved. If not qualified, do not a empt installa on, service or maintenance.
 To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts, abrasions and other hazards, please read all
warnings and instruc ons included with the luminaire, on the luminaire's packaging and affixed to the luminaire itself.
 Maintenance of the luminaires should be performed by person(s) familiar with the luminaire's construc on and opera on and any hazards involved.
WARNING
RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY
 Disconnect or turn off power before a emp ng any installa on,
service or maintenance.
 Verify that supply voltage is correct by referencing the luminaire
label informa on.
 Make all electrical and ground connec ons in accordance with
the Na onal Electrical Code (NEC) and any other applicable laws,
regula ons or codes.
 All wiring connec ons should be capped with UL-approved wire
connectors.
WARNING
RISK OF FIRE OR PERSONAL INJURY
 Keep combus ble materials away from LED/lamp & lens
 Do not operate in close proximity to persons, combus ble
materials or substances affected by heat or drying.
CAUTION
RISK OF PRODUCT DAMAGE
 Never connect luminaires and/or components under load with supply voltage turned on.
 Do not mount or support these luminaires in a manner that can cut the outer jacket or damage wire insula on.
 Do not restrict fixture ven la on. Allow for some volume of airspace around luminaire. Avoid covering luminaire with insula on, foam or other material that
will prevent convec on or conduc on cooling.
 Do not exceed luminaire maximum ambient temperature.
 Do not modify the luminaire.
 Only use luminaire in its intended applica on and loca on.
 Led products are polarity sensi ve. Ensure proper polarity before installa on.
 Electrosta c Discharge (ESD) can damage LED. Personal grounding equipment must be worn during all installa on and servicing of the luminaire.
 Do not touch individual electrical components as this can cause ESD, shorten LED life, or impact LED performance.
 Some components inside the luminaire may not be serviceable. In the unlikely event your luminaire may require service, stop using it immediately and con-
tact SanMarcos.TSC@philips.co phone 800-227-0758.
 Always read the luminaires complete installa on instruc ons prior to installa on for any addi onal luminaire specific warnings.
 In the case of HID or Fluorescent luminaires, regular re-lamping is required to keep luminaire opera ng within safe limits
 Do not install damaged product. Handling and installing damaged products can poten ally increase the risks men oned In case of damage and/or miss-
ing parts upon arrival of the luminaire, please contact SanMarcos.TSC@philips.co phone 800-227-0758.
 These instruc ons do not purport to cover all details or varia ons in equipment nor to provide every possible con ngency to meet in connec on with instal-
la on, opera on or maintenance. Should further informa on be desired or should par cular problems arise which are not covered sufficiently for the pur-
chaser's or owner's purposes, this ma er should be referred to SanMarcos.TSC@philips.co phone 800-227-0758.
 Please see luminaire specific Installa on and Maintenance Instruc on for addi onal warnings or any applicable FCC or regulatory statements. Failure to
follow any of these Instruc ons could void luminaires warran es.
Luminaire Maintenance
 Regular luminaire maintenance programs are recommended.
 It is recommended to clean the outside of the luminaire and the refractor/lens.
 Frequency of cleaning will depend on ambient dirt level and minimum light output which is acceptable to user.
 If clean water is not sufficient for cleaning, use a neutral, synthe c, not-scratching and not-abrasive cleaning substance.
 Never use alkaline and/or acetous cleaning substances.
 Make sure that the cleaning substance is carefully removed by rinsing with lots of clean water.
 Philips recommends using a cleaning solu on that has a PH between 5 and 8.
 Recycle: For informa on on how to recycle electronic products and components, please visit www.epa.gov.
© 2018 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
P/N 443560819190 Rev A
Page 1 of 4
phone 800-227-0758.
PUREFORM BOLLARD (PBL)
WARNING
RISK OF PERSONAL INJURY
 Wear gloves and safety glasses at all mes when removing luminaire from
carton, installing, servicing or performing maintenance.
 Avoid direct eye exposure to the light source while it is on.
WARNING
RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY
 Allow Led/lamp & lens to cool before handling.
 Do not touch enclosure or light source
 Do not exceed maximum wa age marked on luminaire label.
 Follow all manufacturer's warnings, recommenda ons, instruc ons and
restric ons for driver type, burning posi on, moun ng loca ons and
replacement.