Advertisement
If the DVI cable, MDR cable, AC adapter and optical cable are connected, but the transmitter does not operate
correctly, the connectors may be dirty.
Please clean the connectors using this kit.
Cleaning Method
Cleaning the sides of the optical cable end (ferrule)
A cleaner should be used only once. Use one cleaner to clean one location.
Cleaner
part
Cleaner for the sides of the ferrule end.
Cleaning the optical cable end
Ferrule end cleaning sheet
Cleaning the repeater box
A cleaner should be used only once. Use one cleaner to clean one location.
Cleaner
part
2 Insert the cleaner into the back of the connector.
PDA-H05 Cleaning Kit (AZE1141)
1 Place the ferrule end perpendicularly
on the cleaning sheet and rub a few
times (use the same pressure as you
would when writing with a pen).
Repeater box cleaner
Cover the ferrule with the
cleaner and turn five times.
2 Change the cable angle 90° and
clean the ferrule again, using a
different part of the cleaning sheet.
1 Insert the cleaner into the tube
within the connector.
3 After inserting the cleaner into the hole,
turn the cleaner a few times.
Advertisement
