GE eBike Service Manual page 92

Part No. Short Description
2018111-037 SPARE EBIKE MAINS CONNECTOR SET
2018111-038 SPARE EBIKE POWER SWITCH
2018111-039 SPARE EBIKE CABLE MAINS EURO
PCBs eBike:
2018111-040 SPARE EBIKE/C PCB INTERFACE
2018111-137 SPARE EBIKE/B PCB INTERFACE
2018111-041 SPARE EBIKE DIN CONNECTOR SET
- 86 -
Appendix B: Spare Parts
Description
Service Kit: mains connection, kit consisting of:
1x cold-appliance connector, KEA socket
1x cold-appliance connector, KEA drawer for 2 fuses
2x microfuse 5x20 2.0 A slow-blow
2x microfuse 5x20 1.25 A slow-blow
2x screw M3x14
1x hex nut M3
1x spacer pin 3050/28 M3, length 28 mm
1x fixture for power cord 39x32.5x2.5
3x star washer F3.2
1x knurled screw M3x8
Service Kit: power switch with paneling, kit comprising:
1x power switch, pre-assembled, for eBike
1x additional cable connecting the power supply to the power switch
This cable is only intended for power supply versions 1 and 2
(Figure c-12a and c-12b).
1x cable tie
Power cord, grey, length 2.5 m, German connector
PCB Interface kit for eBike comfort with saddle motor:
1x interface module, pre-assembled
4x screw M4x8
PCB Interface kit for eBike comfort without saddle motor:
1x interface module LC, pre-assembled
4x screw M4x8
Service Kit: DIN sockets on PCB Interface, comprising:
1x cable from interface to analog socket (8-pin DIN socket)
1x cable from interface to RS232 (5-pin DIN socket)
eBike, eBike L, eBike EL 2018112-003 Rev J