Advertisement
1. Remove the baffle plates from the top and rear
of the battery module.
3. Install the battery module and reinstall
the fastener of the fuse board with J2
upward.
5. Connect the negative battery cable of the
battery string on the fuse board to the battery
module wiring terminal.
2. Remove the fastener of the fuse board.
4. Install battery cables at one side and bind
the cables, as shown in the following figure.
1. Bind the cables where the positive
and negative terminals are close,
as shown in the preceding figure.
Otherwise, the cables may camber.
2. The negative cable of the battery
module that is connected to the
battery module wiring terminal is
long. Route it through the short
cables, as shown in the left figure.
7
Cable
ties
Advertisement
