Equipment Assembly; Pre-Assembly Inspection; Install Handle Set - GE T2100 Service Manual

Equipment Assembly

Pre-Assembly Inspection

Install Handle Set

3-6
Installation: Equipment Assembly
The GE T2100 Treadmill ships completely assembled except for the
handle set and the emergency stop switch.
As recommended by the American Heart Association Exercise Standards
(Special Report, Vol 82, No 6), the GE T2100 Treadmill should have front
and side rails installed for patients to steady themselves. An emergency
stop switch must be visible and readily accessible. Attach the handle set
and emergency stop switch BEFORE applying power to the unit.
1. If connected, disconnect the power cord from the rear connector
panel.
2. Remove the screws on the shroud back and remove the back panel
and visually inspect the following:
a. Drive Belt – The drive belt is correctly adjusted at the factory,
but may have changed during shipping. Before operating the GE
T2100 Treadmill, verify the tension of the drive belt. See
Belt Adjustments"
b. Drive Motor Mount – Verify that the mounting bolts are
securely tightened.
c. Harnesses – Verify that all wiring harnesses are securely
attached.
d. Elevation Rack – Verify that no obstructions are present in the
elevation racks.
1. Insert the wood front handrail into the metal side rails, then align
the pre-drilled holes and screw in the two Phillips screws on both
sides. Assemble the side rails in the same way.
2. Install the two grommets on the front rail assembly.
3. Place the assembled front handrail into the metal mounting brackets
on the front corners of the shroud. Using the supplied Allen wrench
and four bolts, secure the handrail to the brackets.
4. Place the assembled side rails into the side mounting holes and
screw in the two bolts on each side. Refer to the drawing below for
designation of right side and left side handrails.
GE T2100 Treadmill
2021403-031
on page 7-16 for proper tension tolerances.
"Drive
Revision A