Epson Brightlink Quick Start Manual

Volume adjustments

Hide thumbs Also See for Brightlink:

Download this manual

Epson Brightlink Interactive

Projector – Volume Adjustments

If the volume on your ceiling speakers for your Epson wall mounted projector are not loud

enough, try the following:

STEP #1

Make sure the audio cable is connected securely to the audio jack on the wall plate.

NOTE: There are two different kinds of audio cables in use in the district. One is a part of the

VGA cable, and the other is a separate audio cable.

VGA and Audio

NOTE: VGA must remain plugged in to its

current location.

Page 1 of 4

Audio Only

STEP #2

Plug in the other end of the audio cable to the front

audio jack on your computer.

Page 1 Epson Brightlink Interactive Projector – Volume Adjustments If the volume on your ceiling speakers for your Epson wall mounted projector are not loud enough, try the following: STEP #1 Make sure the audio cable is connected securely to the audio jack on the wall plate.
Page 2 If you have a speaker bar on your monitor, you may connect the audio cable to the speaker bar instead of the front audio jack. Speaker bar must be powered on, and volume must be turned up. Connect audio cable to audio port on left side of speaker bar. Page 2 of 4 ©...
Page 3 STEP #3 If you have external speakers connected to the back your computer, unplug them. STEP #4 Turn the projector on, and project your computer desktop image. Use the remote to make sure that the volume is turned up on the projector. Page 3 of 4 ©...
Page 4 STEP #5 Check to make sure that the volume on your computer is turned up. Double click on the speaker icon near the clock. Windows XP View Windows 7 View Make sure that all volume sliders are turned up to maximum, and that the volume is not muted. Windows XP View Windows 7 View STEP #6...