Electrolux 6 GN 1/1 User Manual page 32

Anom- Type of
Description
aly anomaly
Htd Stops oven Drain temperature
above safety limit
LPIn Stops Boiler level sensor
cycle problem
MCbM Stops oven Lower inverter commu-
nication problem
MCtM Stops the Upper inverter commu-
oven nication problem
PFAC Stops oven Factory parameters
map corrupted
SbbU Stops Boiler gas fan speed
boiler gas issue
SbCd Stops Cavity lower gas
cycle burner blower speed
issue
SbCU Stops Cavity upper gas
cycle/ burner blower speed
convection issue
Water boiler working
SLUS Stops
boiler level not reached in
cycles time
If the fault persists after carrying out the above checks, contact the Customer Care Service, remembering to specify:
A. the type of fault;
B. the appliance PNC (production number code);
C. the Ser. No. (appliance serial number).
NOTE!
The appliance PNC and serial number are essential for identifying the type of appliance and date of manufacture:
32
Possible causes
Possible lack of water in the
drain system.
• Humid lime shortcutting
boiler level sensors.
• Insulation issues with the
boiler level sensors
• Issue with the motor
inverter;
• Connection or electrical
issue.
• Issue with the motor
inverter;
• Connection or electrical
issue,
Issue with the SW or with
the HW
• Burner blower motor
overload due to dirt or
oxidation;
• Other electrical/mechani-
cal issue.
• Burner blower motor
overload due to dirt or
oxidation;
• Other electrical/mechani-
cal issue.
• Burner blower motor
overload due to dirt or
oxidation;
• Other electrical/mechani-
cal issue.
• Water supply valve
closed or partly closed;
• Temporary lack of water
supply pressure;
• Boiler water level sensor
failure;
• Boiler leakage: drain
valve or fracture.
Actions
• Check that the oven has water supply;
• Pour some water on the bottom cavity filter;
• Wait for the alarm to blink off;
• If the problem persists, call Service.
The oven can continue to operate in convection
or in ISG mode.
• There is a problem with the water level in the
boiler: run a cleaning program including the
rinse and descale cycle and use 2 tabs C25
only. (Follow the procedure as per User
Manual);
• If the problem persists, call Service.
Communication error with lower cavity motor
inverter.
• Try to switch the oven OFF/ON.
• If the problem persists, call Service.
Communication error with upper cavity motor
inverter.
• Try to switch the oven OFF/ON.
• If the problem persists, call Service.
• Try to switch the oven OFF/ON.
• If the problem persists, call Service.
Burner fan does not reach the desired speed.
Call Service.
Burner fan does not reach desired speed.
Call Service.
Burner fan does not reach desired speed.
Ovens with boiler can cook in 100℃ steam
mode. To restore full oven functionality call
Service.
• Ensure the water supply valve is fully open
and the water filter has no obstructions. Clean
it if needed;
• The oven can continue to work in Convection
mode;
• Unless the water is missing from the mains,
the oven can continue to work in recovery
mode
• Call Service to restore boiler functionality.