Fitting Special Roof Hooks For Slate/Shingles; Installing The Profile Rails - Bosch TSS Series Installation And Maintenance Instructions Manual

6.5

Fitting special roof hooks for slate/shingles

NOTICE:
Unprofessional work may lead to the roof leaking!
▶ Have a qualified roofer carry out the installation.
▶ To ensure a watertight installation, insert a plate on site [3]
underneath the special roof hook.
▶ Fit the special roof hook at the front with gaskets [2] and the screw
[1].
▶ Adequately secure the special roof hook at the back on the roof
substrate.
4
Fig. 28 Example figure
[1] Screw 6 × 70 (4 × )
[2] Gaskets (on site)
[3] Plate (on site)
[4] Fitted special roof hook
6.6

Installing the profile rails

Fig. 29 Correctly positioning the profile rails for the storage tank
TSS – 6720887693 (2018/10)
1
2
3
6720640298.20-2.ST 6720640298.20-2.ST
0010015742-01 0010015742-01
▶ Place the the profile rails in the centre and screw in each retaining
block with two short screws M8 × 16.
1
M8x16 M8x16
2
Fig. 30 Installing the upper and lower profile rails
It is important for the subsequent collector installation that the profile
rails are accurately aligned! Use assembly aids, e.g. a roof batten [1].
▶ Level the profile rails horizontally and with the stated clearance. Use
a spirit level.
▶ Align sides of the upper and lower profile rails with each other.
▶ Check that they are at right angles. Measure the diagonals or place a
roof batten, for example, at the ends of the profile rails.
▶ Tighten screws M8.
1
90°
Fig. 31 Precisely align the profile rails
Installing the roof connection
1
M8x16 M8x16
2
0010015743-01 0010015743-01
1
90°
90°
1
0010015754-01 0010015754-01
15