Table of Contents
Advertisement
Specifications
Reel Construction: Fairway reels. All welded. 5, 7 or 11
blades.
Height-Of-Cut Range: 5 Blade - 3/4" to 1-1/2" (19ñ38
mm) 7 Bladeñ1/2" to 1ñ1/8" (13ñ29 mm) 11 Bladeó3/8"
to 3/4" (10ñ19 mm)
NOTE: Use bedknife Part No. 93-9774 for height of
cuts below 1/2" (13 mm).
Reel Diameter: 7 in. (178 mm)
Power Attachment: Reel motors feature quick
disconnect for removal or installation onto the cutting
unit. Cutting units can be driven from either end.
Height-of-cut & Roller Adjustment: Height-of-cut
adjustment is made at the rear roller with the quick
locating pin and/or the threaded micro adjustment. Front
roller position is adjustable to set cutting unit attitude.
Bedknife And Bedbar Adjustment: Single-point
adjustment mechanism.
Clip Frequency: .375"ñ1.25" (10ñ32 mm).
Automatic Clip Control: The Reelmaster 6000D series
traction unit is equipped with an electronic controller
that is programmed to achieve automatic clip control.
As the traction unit speed varies, the controller will
automatically adjust the hydraulic flow to the reel motors
to vary reel speed and maintain proper clip. For proper
clip, the controller needs to know what cutting units are
installed (5, 7 or 11 blade) and the height of cut.
NOTE: Refer to the traction unit operatorís manual for
proper set-up procedure.
Rollers: The front roller is a 3" (76 mm) diameter cast
Wiehle roller. The rear roller is a 3" (76 mm) diameter
steel full roller. Both rollers use the same heavy-duty
ball bearings with two conventional single-lip seals and a
Toro labyrinth seal to provide four sealing surfaces to
protect the bearings.
6
Optional Equipment
Dethatching Cutting Unit
Grass Basket Kit
High Torque Reel Motor
Shoulder Wiehle Roller
Full Front Roller
Wiehle Roller Scraper
Rear Roller Scraper Kit
Shoulder Wiehle Scraper
Full Front Roller Scraper
Low Height of Cut Bedknife
Gauge Bar Assembly
Angle Indicator
Backlapping Brush Assembly Part No.
Bedknife Screw Too[
Cutting Unit Tool Kit
Reel Drive Shaft
* For height of cut below 0.5" (13 mm)
Model No. 03871
Model No. 03882
Part No. 98-2448
Part No. 99-8675
Part No. 93-3040
Part No. 95-7729
Part No. 99-5730
Part No. 99-8670
Part No. 99-8668
Part No. 93-9774*
Part No. 98-1852
Part No. 99-3503
TOR299100
Part No. TOR510880
Part No. TOR4070
Part No. TOR4074
Advertisement
Table of Contents
