Advertisement
7
Adjusting the Basket Position
No Parts Required
Procedure
Make sure that the basket is parallel to the cutting unit with
a minimum clearance of 6 mm (0.250 inches) between the
lip of the basket and the reel. If an adjustment to the basket
position is required, proceed as follows:
1. On each side of the basket, loosen the carriage bolt
nuts securing the basket-stop brackets to the basket
(Figure
8).
1. 0.250 clearance
2. Basket-stop bracket
3. Basket
2. Position the basket so it is parallel to the cutting unit
with a minimum clearance of 6 mm (0.250 inches)
between the lip of the basket and the reel
3. On each side of the basket, adjust the basket-stop
brackets so they each contact a carrier-frame arm.
4. Tighten the carriage-bolt nuts to secure the basket
position.
Figure 8
4. Carrier-frame arm
5. Contact point
(Figure
8).
6
Advertisement
