Double-Insulated Appliances - Toro 1800 Power Curve Operator's Manual

1. Bolt (left-hand thread)
2. Washers
3. Small pulley
6. Remove and discard the small belt (Figure 21).
7. Slide 2 washers onto the bolt and insert the bolt through the small
pulley.
Note: The bolt must ride on the bearings in the small pulley.
8. Place the new belt on the small pulley.
9. Slide the belt over the motor shaft pulley (Figure 21).
10. Torque the bolt to 25 to 30 in-lb (2.8 to 3.4 N·m). Do not overtighten
the bolt.
Note: The bolt, the bolt head, and the washers must be flush
against the small pulley.
11. Slip the large belt over the small pulley (Figure 21). Refer to
Replacing the Large Belt.
Service
Toro has designed this product to give you years of trouble free use.
Should it need service, bring the product to your Authorized Toro
•
•
Figure 21
4. Small belt
5. Motor shaft pulley
Service Dealer. Your Toro Dealer is specially trained to repair Toro
products and will ensure that your Toro stays "All" Toro.

Double-insulated Appliances

In a double-insulated appliance, two systems of insulation are
provided instead of grounding. No grounding means is provided on
a double-insulated appliance, nor should a means for grounding
be added to the appliance. Servicing a double-insulated appliance
requires extreme care and knowledge of the system, and should be
done only by the qualified service personnel at your Authorized Toro
Service Dealer. Replacement parts for a double-insulated appliance
must be identical to the parts they replace. A double-insulated
appliance is marked with the words "Double Insulation" or "Double
Insulated." The symbol (square within a square)
marked on the appliance.
Product Information
A model and serial number decal is located on the housing. Always
refer to specific numbers o the decal in correspondence or when you
need replacement parts.
Storage
1. Run the snowthrower for a few minutes to melt away any snow on
the snowthrower.
2. Disconnect the extension cord from the snowthrower.
3. Examine the extension cord thoroughly for signs of wear or
damage. Replace it if it is worn or damaged.
4. Examine the snowthrower thoroughly for worn, loose, or damaged
parts. To repair or replace parts, contact an local Authorized
Service Dealer for assistance.
5. Store the extension cord with the snowthrower.
6. Store the snowthrower in a clean, dry place.
8
may also be
,