Advertisement
6
Installing the Rear Lamps
Parts needed for this procedure:
1
Left rear lamp assembly
1
Right rear lamp assembly
4
Washer head screw, 3/8 x 3/4 inch
Procedure
1. Using the mounting holes to the rear of the hood
latches, secure a lamp assembly to each side of the rear
frame with 2 washer head screws (3/8 x 3/4 inch)
(Figure
8). If the mounting holes are not in the rear
frame, process to the next step
1. Washer head screw
2. Lamp assembly
2. Using the dimensions shown in
and drill 2 holes (9 mm or 0.350 inch in diameter) in
each side of the rear frame. Center the holes up and
down on the frame.
Figure 8
3. Mounting hole
Figure
9, locate, mark
1. 2.25 inches (57 mm)
2. 2.55 inches (65 mm)
7
Connecting the Wiring
Harness
Parts needed for this procedure:
1
Grommet
13
Cable tie, 7–1/4 inch (184 mm)
2
Cable tie, 14–1/2 inch (368 mm)
Procedure
Route, connect and secure the wire harness as follows:
•
Route the end of the harness with the 5 connectors up and
through the knockout hole in the floor plate
•
Route the harness connectors up the steering column and
plug them into the appropriate connectors. Cable tie the
harness to the steering column with cable ties.
1. Knockout plug location
5
Figure 9
3. .350 inch diameter (9 mm)
(Figure
Figure 10
2. Grommet
10).
Advertisement
