Advertisement
1. Underside of the dash
2. Main wiring harness
3. Power plug assembly
6. Connect the two single red wires to the fuse installed in the solenoid plate.
7. Locate the OPTIONS +48 VDC plug on the main vehicle harness, remove the cap.
8. Connect the plug marked +48 VOLTS IN on the 12V converter harness to the plug marked OPTIONS +48
VDC on main vehicle harness.
9. Transfer the cap removed previously to the open OPTIONS 48 VDC on the 12V converter harness.
10. Install the remaining length of the harness along the existing main harness. Use plastic ties to secure the 12V
converter harness to main vehicle harness.
11. Close the hood. Secure it using the latches.
12. Reconnect the battery cable removed previously and lower the bed.
5
3
4
2
Figure 9
4. Plug, power plug
5. Plug, shown transparent for illustration purposes
5
1
G005323
Advertisement
