Philips Jewel FC9069 Manual page 7

Telescopic tube (specific types only)
1 Adjust the tube to the length you find most comfortable during vacuum cleaning (Fig. 5).
Tri-Active nozzle (specific types only)
- The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors (Fig. 6).
The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean better
along furniture and other obstacles.
- The opening at the front of the nozzle allows you to suck up larger particles (Fig. 7).
Hard floor setting:
1 Push the rocker switch on top of the nozzle with your foot to make the brush strip come
out of the housing. At the same time the wheel will be lifted to prevent scratching and to
increase manoeuvrability (Fig. 8).
Carpet setting:
1 Push the rocker switch again to make the brush strip disappear into the nozzle housing. The
wheel will be lowered automatically (Fig. 9).
Convertible nozzle (specific types only)
The convertible nozzle can be used on either carpets or hard floors.
- Push the rocker switch on top of the convertible nozzle with your foot to make the brush strip
for cleaning hard floors come out of the nozzle housing (Fig. 10).
- Push the rocker switch again to make brush strip disappear into the convertible nozzle housing
again. (Fig. 11)
Crevice tool, small nozzle and small brush
1 Connect the crevice tool (1), the small nozzle (2) or the small brush (3) (specific types only)
directly to the handgrip or to the tube (Fig. 1).
Accessory clip (specific types only)
- The accessory clip can simply be snapped onto the tube (Fig. 13).
The crevice tool and the small nozzle can be snapped onto the clip.
Accessory holder (specific types only)
- The accessory holder can simply be snapped onto the handgrip (Fig. 14).
The accessories can be stored in the accessory holder by pushing them into the holder. To detach
the accessories, pull them out of the holder.
You can store two accessories at a time in the accessory holder:
- Crevice tool and small nozzle (Fig. 15).
Please note the way in which the small nozzle must be placed in the accessory holder.
- Crevice tool and small brush (Fig. 16).
Using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
 Switch the appliance on by pressing the on/off button on top of the appliance with your
foot (Fig. 17).
- During vacuum cleaning you can adjust the suction power by means of the knob on top of the
appliance (Fig. 18).
- Use maximum suction power for vacuum cleaning very dirty carpets and hard floors.
- Use minimum suction power for vacuum cleaning curtains, table carpets, etc.
English
7