Attaching Bracket (D); Attaching Adjusting Block (C) - Hitachi HAS-WM03 User Manual

5 Attach the bracket (D) to the LCD projector using four M4 × 8 (G) hexagon
head screws.
Tightening torque: 0.98 N•m (10 kgf•cm)
Note:
Make sure that the bracket
(D) is correctly oriented.
■ Never use screws other than those designated.
nut
Failure to heed this warning may cause the projector to fall or
other hazard resulting in damage or injury.
6 Attach the adjusting block (C) to the arm bracket (IN) using four M4 dish screws (K).
Adjust according to projection screen size and attach as shown in the figure.
Tightening torque: 0.98 N•m (10 kgf•cm)
ock
Projection Projection
direction direction
WARNING
（K）
Projection screens smaller than 70 inches
HAS-WM03
Projection Projection
direction direction
Place cushioning material on a workbench.
Turn over the projector and place it upside
down on the cushioning material on the
workbench.
Note: The adjusting knobs
should face the direction
shown in the figure.
Arm bracket (IN)
Adjusting block(C)
Projection screens 70 inches or larger
11
M4 × 8 hexagon head
screws(G)
(D)
CAUTION
■ Assemble the adjusting
block (C) according to
projection screen size.
（K）