Correct Curled Media Via The Control Panel - Canon Decurler Unit-C1 Operation Manual

Correct Curled Media via the Control Panel

Correct Curled Media via the Control Panel
Introduction
This procedure describes how to correct curled media via the control panel. Make test prints on
the adjusted media to check the curl.
IMPORTANT
You are advised to make small increments to avoid paper jams.
NOTE
You can also correct curled media via the Settings Editor.
NOTE
If the curl correction values are different for LEF and SEF, you must create two media in the
media catalog. One media for LEF and another media for SEF.
NOTE
You can correct curled media while the system prints a job. The curl is corrected after a couple
of sheets.
When you want to correct the curled media immediately:
1. Stop the active job on sheet boundary.
2. Correct the curled media.
3. Resume the job.
The curl is corrected immediately after you resumed the job.
Procedure
1. Touch [System] -> [Media].
2. From the [Media catalog], select the media you want to correct.
3. Touch [Curl correction].
4. Define the correction.
When the media curls upward, adjust downward (+).
When the media curls downward, adjust upward (-).
5. Touch [OK].
You can also correct curled media via the [Trays] view.
1. Touch [Trays].
2. Select the tray with the media you want to correct.
10 Chapter 2 - Use the decurler
NOTE
When you print a 1-sided job face up, select [Output face up].
When you print a 1-sided job face down, select [Output face down].
When you print a 2-sided job, select [2-sided output].
Canon Decurler Unit-C1