Radio Revision Mode; Switching On The Radio Revision Mode; Led Displays In The Radio Revision Mode - Honeywell 015600.01 Mounting And Connection Instructions

Mounting and Connection Instructions RF BUS-2 wireless receiver
4.

Radio revision mode

The radio revision mode is used prior to the actual permanent installation to determine a suitable mounting site for
transmission and reception. Running the radio revision mode requires an RF BUS-2 wireless receiver and a
stationary radio communication device to be installed, for example the RF 4I/O wireless module, a radio
communication device of the Viewguard PIR RF, wireless motion detector type or a RF Smoke Detector Base.
Please observe the instructions given in the Mounting and Connection Instructions of the radio communication
device in question regarding the radio revision mode.
4.1

Switching on the radio revision mode

The RF BUS-2 wireless receiver must be in the de-energised state.
!
Mount the 9 V battery supply clip to the correct pole of the BUS-2 connection (connection +U and 0V).
The operating time of the RF BUS-2 wireless receiver when operated with a 9 V battery in the radio
revision mode about 10 to 15 hours. The radio revision mode is left again by pulling the 9 V battery off.
For the other radio communication devices, the radio revision mode will be left again automatically after 15
minutes! Please note that no more than 4 radio communication devices may be switched simultaneously
to the radio revision mode!
4.2

LED displays in the radio revision mode

Switch DIP switch 7 to the ON position.
!
Plug in 9 V battery, this puts the RF BUS-2 wireless
!
receiver into the radio revision mode.
Next, also switch the stationary radio communication
!
device selected for the object inspection into the radio
revision mode. Determine a suitable installation site for
the radio communication device by means of object
inspection.
After finishing the radio revision mode, switch DIP switch
!
7 to the OFF position and disconnect the battery again.
The OFF position of the DIP 7 will switch the RF BUS-2
wireless receiver automatically into the normal BUS-2
operating mode.
! DIP switch 7, Position ON, the red LED 1 is lit.
This puts the RF BUS-2 wireless receiver in the radio revision mode.
25