Siemens SINUMERIK 840D sl Function Manual page 61

Fixed addresses with axis extension: Miscellaneous
FA
OVRA
ACC
MEASA
MEAWA
MEAC
SCPARA
VELOLIMA
ACCLIMA
JERKLIMA
1) Not permitted in technology cycles
Settable addresses: Travel to fixed stop
FXS
FXST
FXSW
FOC
FOCON
FOCOF
1) Chapter: "Travel to fixed stop (FXS, FXST, FXSW, FOCON, FOCOF, FOC) (Page 112)"
Settable addresses: Couplings > Generic coupling
CPBC
CPDEF
CPDEL
CPFMOF
CPFMON
CPFMSON
CPFPOS
CPFRS
CPLA
CPLCTID
CPLDEF
CPLDEL
CPLDEN
CPLNUM
CPLDYPRIO
CPLDYVLL
CPLDYVLU
Synchronized actions
Function Manual, 08/2018, 6FC5397-5BP40-6BA2
3.5 Language elements for synchronized actions and technology cycles
2)
Axial feedrate (FA) (Page 84)
Axial override
Axial acceleration
Axial measurement with deletion of distance-to-go
Axial measurement without deletion of distance-to-go
Chapter: "Measurement (MEAWA, MEAC) (Page 109)"
Cyclic measuring
Chapter: "Measurement (MEAWA, MEAC) (Page 109)"
Parameter set changeover
Axial velocity/speed limitation
Axial acceleration limitation
Axial jerk limitation
1)
Activate travel to fixed stop
Torque limit for travel to fixed stop
Monitoring window for travel to fixed stop
Non-modal torque/force limitation
Activate travel with limited torque/force
Deactivate travel with limited torque/force
1)
Block change criterion with active coupling
Create coupling module
Delete coupling module
Behavior of the following axis when switching off the coupling
Behavior of the following axis when switching on the coupling
Synchronization mode during coupling
Synchronized position of the following axis when switching on
Reference system for the coupling module of the following axis
Assigning an axis as leading axis to a following axis
Number of the curve table for the coupling of the following axis
Definition of the reference: Leading axis to following axis
Cancellation of the reference: Leading axis to following axis
Coupling factor: Numerator
Coupling factor: Denominator
Priority of the leading axis for the dynamic limitation
Limitation of the overlaid motion of the leading axis: Lower limit
Limitation of the overlaid motion of the leading axis: Upper limit
Detailed description
61