Cleaning And Care - Electrolux Refine 500 Instruction Manual

ACCESSORIES
PROBLEM
Brush
Static brush
Line clip
Trousers rack with 2 garment clips For hanging trousers and skirts. Push up the trouser rack along
Garment clip
Protective glove
Ironing board for collar and
sleeve
Auxiliary ironing board
Accessory bag

CLEANING AND CARE

Switch off the product and unplug from the mains. Allow the product to cool down for at least 30 minutes.
10 Remove the water tank from the base unit, drain the remaining water from the water tank.
11 Open the drain valve to thoroughly drain the remaining water from the heating unit and wipe the re-
maining water on the steam outlet and the base unit to prevent scaling. After draining, close the drain
valve.
In areas with medium water hardness, we recommend to descale the product every 2 months, while in areas
with very hard water, we recommend to descale every 1 month or after 10 sessions.
12 Mix a descaler agent and water at the specified ratio, prepare at least 300ml descaler mixture. (Use
the recommended ratio for the mixture. If there is much scaling, properly increase the proportion of
descaler.)
Note: Please follow the water/descaler liquid ratio instructions on the bottle.
13 Fill the mixture into the water tank, tighten the knob and then place the water tank in the base unit.
Soak for one to two hours under room temperature (if there is much scaling, increase the soaking time;
however, the soaking time should not be longer than 8 hours).
CAUTION: Do not switch on the product during soaking.
14 Pour out the mixture from the water tank and the base unit (refer to Cleaning and Care section, point 10
and 11)
15 Fill in clean water via the steam hose joint and into the water tank and then pour it out. Repeat this
step for several times until the scales in the product are removed and there is no longer a descaler
smell.
16 Reassemble the accessories to continue using it.
www.electrolux.com
POSSIBLE CAUSE
For removing fluff and hair from garments.
For removing the slight dust/fluff by the special static strip on it.
For ironing the shirt sleeves and collars. Just clip it to the tab on the
underside of the nozzle. Place the garment between the nozzle and
the line clip.
the support, it is properly installed after its locking knob hooks the
support of the clothes rack. Evenly hang a pair of trousers or skirt
in the middle of the trousers rack and firmly clip the garment with
trousers clips.
For holding sleeves, dresses and other longer items in place for quick
steaming.
For protection against scalding from the steam released from the
steam nozzle.
For ironing collar, sleeves and pockets.
For smoother and better steaming results, hold the auxiliary ironing
board underneath the garment while steaming the garment.
For storage of accessories.
EN
CNS
CNT
ID
TH
VN
7