Setting Up The Monitor - Dell FPM185 User Manual

Pin No.
7
8
9
10
11
12
13
14
15

Setting up the monitor

To set up the flat-panel monitor:
1 Ensure the monitor has been connected to an AC power source.
2 Pull the monitor tray out.
3 Hold the monitor by its handle and rotate it to a maximum 110-degree
angle.
NOTE: Use the tray's handle to push and pull the tray in the rack.
4 The first time the unit is connected to power, you must touch the power
icon to turn it on. After the first time, the unit will turn on when opened.
NOTE: If power is completely disconnected, the console tray will default into Active-Off
mode.
Signal
Green Video Ground
Blue Video Ground
VCC
Identify VGA Cable Connection
NC
SDA (DDC1/2B)
Horizontal Sync
Vertical Sync
SCL (DDC2B)
Operating the Console Tray
xxx | xxx
12