Table of Contents
Advertisement
Operating
Your Air
Conditioner
In This Section
Page
Using the AUTO COOL Cycle.. ............ 6
Modifying the temperature
................... 7
Modifying the fan speed .......................
7
'
Using the AIR SWING feature ............. 7
Turning the unit off ...............................
8
Using the HEAT ONLY Cycle .............. 8
Using the DRY ONLY Cycle ................ 9
Page
Using the SLEEP HOURS Cycle.. ........ 10
Using the TIMED OFF
HOURS Cycle ......................................
11
Using the CHECK FILTER light.. .......... 11
Modifying the air direction .................... 12
Using the exhaust door ........................
12
Using the remote control ...................... 12
Operating your air conditioner
properly is
essential to obtain the best possible results.
This section tells you about each cycle and
how to operate it.
IMPORTANT:
After turning the unit off, wait
approximately
3 minutes before turning it
back on. If you don't wait approximately
3 minutes, the air conditioner
will try to start,
but turn itself off until the compressor is
ready to start again.
DO NOT disconnect the air conditioner
from its electrical supply. DO NOT use
an electrical outlet that can be turned
off with a switch. When the air condi-
tioner is disconnected
from its electrical
supply (including power outages) all
programming
reverts back to the
factory-preset
information.
However,
the air conditioner
will "relearn" your
preferences.
Using
the AUTO
COOL
Cycle
(Single-Button
Cooling)
AUTO
COOL BURST
The AUTO COOL Cycle is designed to
AUTO COOL BURST cools the room for
provide you with the comfort you desire by
15 minutes before allowing the room to rise
continually
"learning" your preferences.
to your prelearned temperature.
This cycle is
Once the Cycle "learns" what temperature(s)
especially useful if you are hot from exercise
you desire, it automatically
chooses a fan
or it is very hot in the room.
To activate
AUTO COOL BURST:
l
Press the AUTO COOL/ON Button twice.
speed when turned on and cools the room
as quickly as possible.
NOTE: You can modify the fan speed and
temperature
when using the AUTO COOL
Cycle, if desired. See "Modifying the fan
speed" or "Modifying the temperature"
on
page 7.
To activate
the AUTO COOL Cycle:
l
Press the AUTO COOL/ON Button.
NOTE: When the cycle is active, the
indicator light on the AUTO COOL/ON
Button will be lit.
\I/
-m-
/I\
n
AUTO COOL
ON
Advertisement
Table of Contents
