Connecting To A Network - Toshiba dynadock 4K User Manual

Setting Up the dynadock 4K docking station
NOTE
NOTE
NOTE

Connecting to a network

Connect one end of a network cable (not provided) to the
Network port (RJ-45) on the dynadock 4K docking station
and the other end to your network.
If the network is not automatically connected, configure the
network properties of the Ethernet adaptor as follows:
❖
In Windows
and Sharing Center
setting
❖
In Windows 8.1, from the Start screen, begin typing
Control Panel.
and Internet,"
then
In the Network Connections folder, double-click the
Connection
Ethernet adaptor, which is indicated by
opens the Local Area Connection Properties window,
allowing you to configure the network settings as required
according to your network environment. If you are unsure
and Connecting Peripherals
The DVI, HDMI™, or DisplayPort™ cable provides digital
communication between the display and computer, while
the VGA cable provides analog communication. If your
display has a DVI, HDMI™, or DisplayPort™ port, use the
DVI, HDMI™, or DisplayPort™ cable to obtain finer
resolution options.
The display cable can be connected/disconnected at any
time without disconnecting the dynadock 4K docking
station from your computer.
If no output is seen on the display connected to the
dynadock 4K docking station, the current video
resolution setting may not be supported by the display.
This can happen if the display does not report its
supported modes to the dynadock 4K docking
station's video component. Adjust the resolution of the
external display until an image appears. For more
information, see
Utility" on page
®
7, click
.
Click
View network status and tasks
Change adapter settings
icon for the dynadock 4K docking station's
"Using the TOSHIBA dynadock 4K
27.
,
Start Control Panel
, and then
Control Panel
,
Network
Change adapter
, Under "Network
.
. This
dynadock
23
, and