Advertisement
8.3.
ASSEMBLE THE FRONT WALL PANELS
8.3.1.
Place panel 9A and 9S on your work table and join them together with the 10mm long self tapping screws.
See the pre-punched holes and both diagrams.
8.3.2.
Fit top and bottom channels 20B and 20C to panels by firstly sliding and finally tapping into place. Note that the smaller flange on the
channels should always be adjacent to the outside face of the panel. The outside face is the diagram. Fix both with 10mm long self
tapping screws except for positions marked with asterisk *, which are not fixed at this stage.
© Jack Sealey Limited
*
*
Original Language Version
*
*
GSS150819SDG Issue: 1 - 27/08/14
Advertisement
