Table of Contents
Advertisement
Available languages
Available languages
Multiple descaling system
Depending on the model, this range of irons is equipped
with the following de-scaling features "AntiCalc".
1. self-clean
The self-clean ilter between the water tank and the
pump prevents scale impairing the steam generation
system and ensures the optimum production of steam.
2. anti-calc
The "anti-calc" cartridge has been designed to
reduce the build-up of scale produced during steam
ironing, helping to extend the useful life of your iron.
Nevertheless the "anti-calc" cartridge cannot prevent all
of the scale that is produced naturally over time.
3. calc'n clean
The "calc'n clean" function helps to remove scale
particles out of the steam chamber. Use this function
approximately every 2 weeks, if the water in your area
is very hard.
Follow the procedure described below:
a) Remove the plug from the socket, ensure that the
iron has cooled down and that the water tank (11) is
empty.
b) Set the temperature control (15) to the "calc'n clean"
setting.
c) Fill the water tank (11) to the maximum level with
clean tap water.
d) Plug in the iron and select the maximum steam
setting "max" by pressing the steam selection button
(4).
e) Hold the iron over a sink or a container to collect the
water.
f) Grip the handle (1) until the water tank (11) is empty.
This could take several minutes.
g) Repeat the procedure until particles no longer come
out of the soleplate (13) of the iron.
h) Turn the temperature control (15) to the maximum
setting. The iron will begin to emit steam. Wait until
the water inside the iron has evaporated.
i) Clean the soleplate (13) of the iron.
4. calc'n clean with descaling luid
(model dependent)
For deep descaling, use the descaling luid (17)
supplied.
This should be carried out every 3 months.
The descaling luid (17) can be obtained from our After-
sales service or from our website..
Accessory code
(After-sales)
311144
(9)
Name of accessory
(Online shop)
TZ11001
Follow the procedure described below:
a) Remove the plug from the socket, ensure that the
iron has cooled down and that the water tank (11) is
empty.
b) Set the temperature control (15) to the "calc'n clean"
setting.
c) Fill the water tank (11) with tap water mixed with a
measure (25 ml) of the descaling luid (17).
d) Plug in the iron and select the maximum steam
setting "max" by pressing the steam selection button
(4).
e) Hold the iron over a sink or a container to collect the
water.
f) Grip the handle (1) until the water tank (11) is empty.
This could take several minutes.
g) Then follow the procedure described above in section
"3. calc'n clean" until particles no longer come out of
the soleplate (13) of the iron.
Anti-drip system
If the temperature control (15) is set too low (below "••"),
the steam is automatically switched off to prevent water
from dripping out of the soleplate (13).
The "activeControl Plus" indicator lamp (3) on the
handle lashes and the pump will not work.
Fabric-protection soleplate cover
(model dependent)
The fabric-protection is used for steam-ironing delicate
garments at maximum temperature without damaging
them.
Use of the protector also does away with the need for a
cloth to prevent shine on dark materials.
It is advisable to irst iron a small section on the inside
of the garment to see if it is suitable.
To attach the fabric protector to the iron, place the tip
of the iron into the end of the fabric protector and press
the rear of the protector upward until you hear a click.
To release the fabric protector, pull down on the clip at
the rear and remove the iron.
(10)
Advertisement
Table of Contents
