Husqvarna 123HD60 Workshop Manual page 14

2
12
Electrical system
Remove the fl ywheel.
510 13 89-01
Assembly
Check that the key and the key slot in the
crankshaft are undamaged.
Assemble the fl ywheel.
Fit the ignition module.
Adjust the air gap to 0.3 mm.
0.3
502 51 34-02
502 50 19-01
Dismantle the fl ywheel from the crankcase
using the puller no. 510 13 89-01.
Gently knock the puller screw with a
hammer, if the fl ywheel sits tightly on the
crankshaft.
Assembly
Check that the key and the key slot in the
crankshaft are undamaged.
Assemble the fl ywheel.
Fit the ignition module.
NOTE!
Do not forget the insulation sleeves
between the cylinder and ignition
module, and check that they are
turned the right way.
Adjust the air gap. There should be 0.3
mm between the permanent magnets in
the fl ywheel and the ignition module.
Tighten the screws that hold the ignition
module in place and check the air gap
once again.
Assemble other parts in the reverse order
as set out for dismantling.