Pc Input Terminals Connection - Panasonic TH-37PA20U/P Operating Instructions Manual

PC Input Terminals connection

COMPUTER
Conversion adapter
(if necessary)
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
(2) The display resolution is a maximum of 640
when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to
show fine detail with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(5) The computer shown in the illustration is for example purposes only.
(6) Additional equipment and cables shown are not supplied with this set.
(7) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input
Terminal
Ferrite core (small size)
(supplied)
Audio
Connect a cable which matches
the audio output terminal on the computer.
Less than
4" (10 cm)
480 dots when the aspect mode is set to "4:3", and 852
Signal Name
Pin No.
R
1
G
2
3 B
4 NC (not connected)
5 GND (Ground)
Less than
4" (10 cm)
Stereo plug
Less than
4" (10 cm)
RGB
PC cable
Ferrite core (large size)
(supplied)
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
Cable Connection
3
INPUT
S VIDEO VIDEO L AUDIO R PC
D-sub 15p
480 dots
Pin No. Signal Name
11 NC (not connected)
12 NC
13 HD/SYNC
14 VD
15 NC
17