Before You Install - HP 300 Series Software Installation Instruction

Before You Install ...
1. Obtain the tape cartridge for release 7.0 of HP-UX. This tape is labeled as
follows:
HP9000 Series 300 HP-UX INSTALL TAPE
Release 0700, VUF A.B7.00, INSTALL format
DC600 Cart 1 of 1
2. Have a properly configured and tested hardware system as follows:
Computer Series 300, Model 318, 319, 320, 330, 332, 340, 350, 360, 370, or
375 (Model 310 is no longer supported).
Disk drive At least one hard disk drive (for example, an HP 7958 or HP
7937/7936) with:
• approximately 80 Mbytes minimum disk space.
• at least 130 Mbytes recommended for a workstation.
• at least 300 Mbytes recommended for a cluster server.
Tape drive A tape drive that uses an HP Certified Data Cartridge (for
example, an HP 9144).
RAM At least 4 Mbytes; 8 Mbytes recommended. For a cluster
server, at least 8 Mbytes; 16 Mbytes recommended.
For more information on a properly configured system, see available
hardware configuration manuals and data sheets, such as the HP9000 Series
300 Hardware Configuration Guide.
3. When you finish Steps 1 and 2, above, go on to Chapter 2. A typical
installation takes 4 to 6 hours, depending on how much software you load.
Introducing Series 300 7.0 HP-UX Installation 1-7